SPEAR-09-B042 datasheet(45/66 Pages) STMICROELECTRONICS

45 / 66 page

SPEAR-09-B042

Standard customization

45/66

9.4.5

TDM interface

The TDM block implements time division multiplexing with up to 1024 time slots. It uses 11

pins.

The TDM interface can be the master or a slave of the CLK or SYNC0 signals.

It is a master when generating SYNC1 to SYNC7, which are seven additional sync signals

for devices that do not recognize time slots, or which need a special synchronization

waveform.

DIN receives the data.

DOUT transmits the data. This line can be high impedance on timeslot not used.

Timeslots can be used in two ways: switching or bufferization. The information about

timeslot usage is written in a 1024*32 memory, termed the 'action memory'. Switching and

bufferization can be used concurrently for different timeslots on the same TDM. The only

limitation is that an output timeslot can not be switched and bufferized at the same time.

Clock signal: device can be master or slave.

In master mode the CLK signal can be generated from different sources:

●

ClkR_Osci1: MCLK clock from external MCLK crystal

●

ClkR_Gpio4: external oscillator from PL_CLK4 pin.

●

ClkR_Synt_3: From frequency synthetiser (source is AHB frequency).

All three signals can be divided by the TDM_CLK block in order to obtain the correct

frequency.

In slave mode, the clock is received on the TDM_CLK pin.

The clock used internally is present on the PL_CLK pins.

Sync signal: device can be master or slave.

SYNC0 can be master or slave. SYNC1 to SYNC7 are additional generated synchro

dedicated to devices that does not recognize the timeslots orwhich need special waveforms.

SYNC1 to SYNC3 are built from SYNC0.

Sync0 in slave and master mode and Sync1 to Sync3 support several pre-defined wave

shapes.

SYNC4 to SYNC7 are generated using the SYNC memory (1024*32) where each bit is set

to 0 or 1 to generate the right pattern on the pin during a frame.

Table 16.

TDM block pins

Pins

Description

SYNC7-0

Dedicated frame synchro for CODECs without timeslot recognition

CLK

TDM clock

DIN

TDM input

DOUT

TDM output (tri-state)

SPEAR-09-B042 Datasheet(PDF) 45 Page - STMicroelectronics

SPEAR-09-B042 Datasheet(HTML) 45 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66

Datasheet Download

Link URL