H8SLASH3003 datasheet(300/715 Pages) RENESAS

300 / 715 page

— PWM mode

PWM output can be provided with an arbitrary duty cycle. With synchronization, up to

five-phase PWM output is possible

•

Phase counting mode selectable in channel 2

Two-phase encoder output can be counted automatically.

•

Three additional modes selectable in channels 3 and 4

— Reset-synchronized PWM mode

If channels 3 and 4 are combined, three-phase PWM output is possible with three pairs of

complementary waveforms.

— Complementary PWM mode

If channels 3 and 4 are combined, three-phase PWM output is possible with three pairs of

non-overlapping complementary waveforms.

— Buffering

Input capture registers can be double-buffered. Output compare registers can be updated

automatically.

•

High-speed access via internal 16-bit bus

The 16-bit timer counters, general registers, and buffer registers can be accessed at high speed

via a 16-bit bus.

•

Fifteen interrupt sources

Each channel has two compare match/input capture interrupts and an overflow interrupt. All

interrupts can be requested independently.

•

Activation of DMA controller (DMAC)

Four of the compare match/input capture interrupts from channels 0 to 3 can start the DMAC.

•

Output triggering of programmable pattern controller (TPC)

Compare match/input capture signals from channels 0 to 3 can be used as TPC output

triggers.

282

H8/3003 Datasheet(PDF) 300 Page - Renesas Technology Corp