WM1811A datasheet(96/328 Pages) WOLFSON

96 / 328 page

WM1811A

Production Data

PD, November 2013, Rev 4.1

DIGITAL TO ANALOGUE CONVERTER (DAC)

The WM1811A DACs receive digital input data from the DAC mixers - see “Digital Mixing”. The digital

audio data is converted to oversampled bit streams in the on-chip, true 24-bit digital interpolation

filters. The bitstream data enters two multi-bit, sigma-delta DACs, which convert them to high quality

analogue audio signals. The multi-bit DAC architecture reduces high frequency noise and sensitivity to

clock jitter. It also uses a Dynamic Element Matching technique for high linearity and low distortion.

A high performance mode of DAC operation can be selected by setting the DAC_OSR128 bit - see

“Clocking and Sample Rates” for details.

The analogue outputs from the DACs can be mixed with analogue line/mic inputs using the line output

mixers MIXOUTL / MIXOUTR and the speaker output mixers SPKMIXL / SPKMIXR.

The DACs are enabled using the register bits defined in Table 50.

Note that the DAC clock must be enabled whenever the DACs are enabled.

ADDRESS

BIT

LABEL

DEFAULT

DESCRIPTION

R5 (0005h)

Power

Management (5)

DAC1L_EN

Left DAC Enable

0 = Disabled

1 = Enabled

DAC1R_EN

Right DAC Enable

0 = Disabled

1 = Enabled

Table 50 DAC Enable Control

DAC CLOCKING CONTROL

Clocking for the DACs is derived from SYSCLK.The required clock is enabled when the

SYSDSPCLK_ENA register is set.

The DAC clock rate is configured automatically, according to the AIFn_SR, AIFnCLK_RATE and

DAC_OSR128 registers. (See “Clocking and Sample Rates” for further details of the system clocks

and control registers.)

When AIF1CLK is selected as the SYSCLK source (SYSCLK_SRC = 0), then the DAC clocking is

controlled by the AIF1_SR and AIF1CLK_RATE registers.

When AIF2CLK is selected as the SYSCLK source (SYSCLK_SRC = 1), then the DAC clocking is

controlled by the AIF2_SR and AIF2CLK_RATE registers.

The supported DAC clocking configurations are described in Table 51 (for DAC_OSR128=0) and

Table 52 (for DAC_OSR128=1). Under default conditions, the DAC_OSR128 bit is not set.

WM1811A Datasheet(PDF) 96 Page - Wolfson Microelectronics plc

WM1811A Datasheet(HTML) 96 Page - Wolfson Microelectronics plc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL