HC705RC17GRSSLASHD datasheet(71/126 Pages) NXP

71 / 126 page

Carrier Modulator Transmitter (CMT)

Carrier Generator

MC68HC705RC17 — Rev. 2.0

General Release Specification

Carrier Modulator Transmitter (CMT)

PH0–PH5 and PL0–PL5 — Primary Carrier High

and Low Time Data Values

When selected, these bits contain the number of input clocks required

to generate the carrier high and low time periods. When operating in

time mode (see 9.5.1 Time Mode), this register pair is always

selected. When operating in FSK mode (see 9.5.2 FSK Mode), this

under control of the modulator. The primary carrier high and low time

values are undefined out of reset. These bits must be written to non-

zero values before the carrier generator is enabled to avoid spurious

results.

NOTE:

Writing to CHR1 to update PH0–PH5 or to CLR1 to update PL0–PL5 will

also update the IRO latch. When MCGEN (bit 0 in the MCSR) is clear,

the IRO latch value appears on the IRO output pin. Care should be taken

that bit 7 of the data to be written to CHR1 or CHL1 should contain the

desired state of the IRO latch.

SH0–SH5 and SL0–SL5 — Secondary Carrier High

and Low Time Data Values

When selected, these bits contain the number of input clocks required

to generate the carrier high and low time periods. When operating in

time mode (see 9.5.1 Time Mode), this register pair is never selected.

When operating in FSK mode (see 9.5.2 FSK Mode), this register pair

and the secondary register pair are alternately selected under control

of the modulator. The secondary carrier high and low time values are

undefined out of reset. These bits must be written to nonzero values

before the carrier generator is enabled when operating in FSK mode.

IROLN and IROLP — IRO Latch Control

Reading IROLN or IROLP reads the state of the IRO latch. Writing

IROLN updates the IRO latch with the data being written on the

negative edge of the internal processor clock (fosc/2). Writing IROLP

updates the IRO latch on the positive edge of the internal processor

clock; for example, one fosc period later. The IRO latch is clear out of

reset.

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

HC705RC17GRS/D Datasheet(PDF) 71 Page - NXP Semiconductors