HC705JJ7GRSSLASHD datasheet(61/230 Pages) NXP

61 / 230 page

Resets

Power-On Reset

MC68HC705JJ7/MC68HC705JP7 — Rev. 3.0

General Release Specification

Resets

5.3 Power-On Reset

A positive transition on the VDD pin generates a power-on reset. The

power-on reset is strictly for conditions during powering up and cannot

be used to detect drops in power supply voltage.

A delay of 16 or 4064 internal bus cycles (tCYC) after the oscillator

becomes active allows the clock generator to stabilize. If the RESET pin

is at logic zero at the end of this multiple tCYC time, the MCU remains in

the reset condition until the signal on the RESET pin goes to a logic one.

5.4 External Reset

A logic zero applied to the RESET pin for a minimum of one and one half

tcyc generates an external reset. This pin is connected to a Schmitt

trigger input gate to provide an upper and lower threshold voltage

separated by a minimum amount of hysteresis. The external reset

occurs whenever the RESET pin is pulled below the lower threshold and

remains in reset until the RESET pin rises above the upper threshold.

This active low input will generate the internal RST signal that resets the

CPU and peripherals.

The RESET pin can also be pulled to a low state by an internal pulldown

device that is activated by three internal reset sources. This RESET

pulldown device will only be asserted for three to four cycles of the

internal bus or as long as the internal reset source is asserted.

NOTE:

Do not connect the RESET pin directly to VDD, as this may overload

some power supply designs if the internal pulldown on the RESET pin

should activate. If an external reset function is not required, the RESET

pin should be left unconnected.

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

HC705JJ7GRS/D Datasheet(PDF) 61 Page - NXP Semiconductors