| Electronic Components Datasheet Search |
|
68HC05P9A Datasheet(PDF) 35 Page - Freescale Semiconductor, Inc |
|
|
|||||||||||||||||||||||||||||
68HC05P9A Datasheet(HTML) 35 Page - Freescale Semiconductor, Inc |
|
35 / 90 page ![]() GENERAL RELEASE SPECIFICATION LOW POWER MODES Rev. 2.0 6-1 SECTION 6 LOW POWER MODES The MC68HC05P9A is capable of running in a low-power mode in each of its configurations. The WAIT and STOP instructions provide two modes that reduce the power required for the MCU by stopping various internal clocks and/or the on- chip oscillator. The STOP and WAIT instructions are not normally used if the COP watchdog timer is enabled. The stop conversion mask option is used to modify the behavior of the STOP instruction from stop mode to halt mode. The flow of the stop, halt, and wait modes is shown in Figure 6-1. 6.1 STOP Instruction The STOP instruction can result in one of two modes of operation, depending on the stop conversion mask option. If the stop conversion is not chosen, the STOP instruction will behave like a normal STOP instruction in the MC68HC05 Family and place the MCU in the stop mode. If the stop conversion is chosen, the STOP instruction will behave like a WAIT instruction (with the exception of a variable delay at startup) and place the MCU in the halt mode. 6.1.1 Stop Mode Execution of the STOP instruction without conversion to halt places the MCU in its lowest power consumption mode. In the stop mode the internal oscillator is turned off, halting all internal processing, including the COP watchdog timer. Execution of the STOP instruction automatically clears the I bit in the condition code register so that the IRQ external interrupt is enabled. All other registers and memory remain unaltered. All input/output lines remain unchanged. The MCU can be brought out of the stop mode only by an IRQ external interrupt or an externally generated RESET. When exiting the stop mode, the internal oscillator will resume after a 4064 PH2 clock cycle oscillator stabilization delay. NOTE Execution of the STOP instruction without conversion to halt (via mask option) will cause the oscillator to stop, and therefore disable the COP watchdog timer. If the COP watchdog timer is used, the stop mode should be changed to the halt mode by selecting the appropriate mask option. Freescale Semiconductor, Inc. For More Information On This Product, Go to: www.freescale.com |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |