| Electronic Components Datasheet Search |
|
AT89LP51RB2 Datasheet(PDF) 88 Page - ATMEL Corporation |
|
|
|||||||||||||||||||||||||||||
AT89LP51RB2 Datasheet(HTML) 88 Page - ATMEL Corporation |
|
88 / 254 page ![]() 88 3722A–MICRO–10/11 AT89LP51RB2/RC2/IC2 Preliminary Note: In Fast Mode, TPS applies only when the T2X2 bit in CKCON0 is set. TPS always applies in Compatibility Mode, therefore setting T2X2 in Compatibility Mode will halve the timer frequency. In the Counter function, the register is incremented in response to a 1-to-0 transition at its corre- sponding external input pin, T2. In Fast mode the external input is sampled every clock cycle. When the samples show a high in one cycle and a low in the next cycle, the count is incre- mented. The new count value appears in the register during the cycle following the one in which the transition was detected. Since 2 clock cycles are required to recognize a 1-to-0 transition, the maximum count rate is 1/2 of the system frequency. There are no restrictions on the duty cycle of the input signal, but it should be held for at least one full clock cycle to ensure that a given level is sampled at least once before it changes. In Compatibility mode the counter input sampling is controlled by the prescaler. Since TPS defaults to 6 in this mode, the pins are sampled every six system clocks. Therefore the input sig- nal should be held for at least six clock cycles to ensure that a given level is sampled at least once before it changes. The following definitions for Timer 2 are used in the subsequent paragraphs: Table 14-1. Timer 2 Operating Modes RCLK + TCLK CP/RL2 DCEN T2OE TR2 MODE 00 0 0 1 16-bit Auto-reload 00 1 0 1 16-bit Auto-reload Up-Down 01 X 0 1 16-bit Capture 1 XXX 1 Baud Rate Generator XX X 1 1 Frequency Generator X X X X 0 (Off) Table 14-2. Timer 2 Definitions Symbol Definition MIN 0000H MAX FFFFH BOTTOM 16-bit value of {RCAP2H,RCAP2L} fTIMER f SYS 2 T2X2 TPS 1 + () × ------------------------------------------------ = Compatibility Mode fTIMER fSYS TPS 1 + --------------------- = Fast Mode and T2X2 = 1 f TIMER f SYS = Fast Mode and T2X2 = 0 |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |