AD4080BBCZ datasheet(34/95 Pages) AD

34 / 95 page

Data Sheet

AD4080

DIGITAL INTERFACE

analog.com

Rev. 0 | 34 of 95

Table 15. Address Ascension Selection

ADDR_ASCENSION Bit

Value

Address Controller Behavior

(STRICT_REGISTER_ACCESS = 1)

0 (Default)

Decrement Address. Multibyte registers are accessed

by addressing the most significant byte address.

Increment Address. Multibyte registers are accessed

by addressing the least significant byte address

Figure 53 illustrates the generic SPI frame formatting for a serial

transaction using the default interface configuration. In this exam-

ple, a portion of the configuration register space consisting of

a byte-wide register and a multibyte register is accessed. The

address for the byte-wide register resides in the most significant

address (ADDRESS) and the most significant byte of the multibyte

segment. By default, the ADDR_ASCENSION property is set to

descending, indicating that the address for the most significant

phase. Depending on the selected operation, the instruction word

is followed by either a payload consisting of data for the byte-wide

bytes (MSBYTE) of the multibyte register, or, in the case of a

read access, padding bits. As a convention, it is recommended to

pass Logic 1 to SDI during a read access to avoid accidentally

addressing address zero for write access.

In single instruction mode (SINGLE_INST = 1), the memory access

controller requires an instruction phase to transmit for each register

accessed in a given SPI frame as illustrated in Figure 54. This

mode is useful when access to nonadjacent sections of the register

space is required in a given SPI frame. Note that, the same access

flexibility can be achieved in stream mode by initiating a new SPI

frame for each unique register access.

The single instruction mode is selected by setting SINGLE_INST

= 1 in the Interface Configuration B register (see the Interface

Configuration B Register section, Address 0x01).

Figure 53. Interface Access Example, Default Interface Configuration, Streaming Mode (ADDR_ASCENSION = 0)

Figure 54. Interface Access Example, Single Instruction Mode (SINGLE_INST = 1), All Other Interface Options Default

AD4080BBCZ Datasheet(PDF) 34 Page - Analog Devices