M68ICS08KX datasheet(30/77 Pages) MOTOROLA

30 / 77 page

User’s Manual

M68ICS08KX In-Circuit Simulator

Preparation and Installation

MOTOROLA

Preparation and Installation

When emulating, connect the 40-pin M68CLB05A flex cable to the

connector labeled J1on the simulator board. Attach the other end of the

cable to the appropriate connector on the target system. Target head

adapters are available.

•

Emulating using a ribbon cable

When emulating, connect a 16-pin flat ribbon cable to connector J5 on

the simulator board. Attach the other end of the cable to the appropriate

connector on the target system.

•

Using a MON08 cable to debug the target system.

NOTE:

An MCU must be installed in the target system. No MCU should on the KXICS.

Connect the MON08 debug interface cable to the appropriate MON08

debug interface connector, J3, for communication with the target

system’s MCU. Attach the other end of the cable to the appropriate

connector on the target system.

NOTE:

For more detailed information on the MONO8, refer to Section 4 of this manual.

2.6 Installing the Software

For instructions for installing the ICS08 software, refer to P&E Microcomputer

Systems, Inc., M68ICS08 68HC08 In-Circuit Simulator Operator’s Manual,

Motorola document order number M68ICS08OM/D.

M68ICS08KX Datasheet(PDF) 30 Page - Motorola, Inc