HC705P6AGRSSLASHD datasheet(88/134 Pages) NXP

Part #	HC705P6AGRS/D

Description	The Motorola MC68HC705P6A is an EPROM version of the MC68HC05P6 microcontroller

PDF	134 Pages

Scroll/Zoom	100%

Manufacturer	NXP [NXP Semiconductors]

Direct Link	http://www.nxp.com

Logo

88 / 134 page

EPROM

General Release Specification

MC68HC705P6A — Rev. 1.0

EPROM

4. Set the PROGRAM and/or VERIFY switches for the desired

operation (an open switch is the active state) and close the

RESET switch to hold the MCU in reset.

5. Make sure that the VPP source is OFF.

6. Apply the VDD source to the programming circuit.

7. Apply the VPP source to the programming circuit.

8. Open the RESET switch to allow the MCU to come out of reset

and begin execution of the software in its internal bootloader

ROM.

9. Wait for programming and/or verification to complete (about 40

seconds). The PROGRAM LED will light during programming and

the VERIFY LED will light if verification was requested and was

successful.

10. When complete, close the RESET switch to force the MCU into

the reset state.

11. Turn off the VPP source.

12. Turn off the VDD source.

13. Remove device(s).

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

HC705P6AGRS/D Datasheet(PDF) 88 Page - NXP Semiconductors