ZSSC3036

Low-Power 16-Bit Sensor Signal Conditioner IC

Data Sheet

May 28, 2013

© 2013 Zentrum Mikroelektronik Dresden AG

— Rev. 1.20

All rights reserved. The material contained herein may not be reproduced, adapted, merged, translated, stored, or used without

the prior written consent of the copyright owner. The information furnished in this publication is subject to changes without notice.

33 of 49

3.6.3.

Memory Contents

Table 3.8

MTP Memory Content Assignments

MTP

Address

Word / Bit

Range

Default

Setting

Description

Notes / Explanations

15:0

Cust_ID0

Customer ID byte 0 (combines with memory word

15:0

Cust_ID1

Customer ID byte 1 (combines with memory word

Interface Configuration

6:0

Slave_Addr

I²C

Mode

8:7

-

Reserved

9

SS_polarity

Determines the polarity of the Slave Select pin (SS)

for SPI operation:

 0  Slave Select is active low (SPI and

ZSSC3036 are active if SS==0)

 1  Slave Select is active high (SPI and

ZSSC3036 are active if SS==1)

11:10

CKP_CKE

Clock polarity and clock-edge select

—determines

polarity and phase of SPI interface clock with the

following modes:

 00  SCLK is low in idle state, data latch with

rising edge and data output with falling edge

 01  SCLK is low in idle state, data latch with

falling edge and data output with rising edge

 10  SCLK is high in idle state, data latch with

falling edge and data output with rising edge

 11  SCLK is high in idle state, data latch with

rising edge and data output with falling edge

15:12

-

Not assigned