TMS320F241FN datasheet(33/66 Pages) TI

33 / 66 page

TMS320C242

DSP CONTROLLER

SPRS063B – DECEMBER 1997 – REVISED DECEMBER 1999

POST OFFICE BOX 1443

• HOUSTON, TEXAS 77251–1443

PWM characteristics

Characteristics of the PWMs are as follows:

D 16-bit registers

D Programmable deadband for the PWM output pairs, from 0 to 24 ms

D Minimum deadband width of 50 ns

D Change of the PWM carrier frequency for PWM frequency wobbling as needed

D Change of the PWM pulse widths within and after each PWM period as needed

D External-maskable power and drive-protection interrupts

D Pulse-pattern-generator circuit, for programmable generation of asymmetric, symmetric, and four-space

vector PWM waveforms

D Minimized CPU overhead using auto-reload of the compare and period registers

capture unit

The capture unit provides a logging function for different events or transitions. The values of the GP timer 2

counter are captured and stored in the two-level FIFO stacks when selected transitions are detected on capture

input pins, CAPx for x = 1, 2, or 3. The capture unit of the TMS320x24x consists of three capture circuits.

D Capture units include the following features:

–

One 16-bit capture control register, CAPCON (R/W)

–

One 16-bit capture FIFO status register, CAPFIFO

–

Selection of GP Timer 2 as the time base

–

Three 16-bit 2-level-deep FIFO stacks, one for each capture unit

–

Three Schmitt-triggered capture input pins CAP1, CAP2, and CAP3, one input pin per each capture

unit. [All inputs are synchronized with the device (CPU) clock. In order for a transition to be captured, the

input must hold at its current level to meet two rising edges of the device clock. The input pins CAP1 and

CAP2 can also be used as QEP inputs to the QEP circuit.]

–

User-specified transition (rising edge, falling edge, or both edges) detection

–

Three maskable interrupt flags, one for each capture unit

quadrature-encoder pulse (QEP) circuit

Two capture inputs (CAP1 and CAP2) can be used to interface the on-chip QEP circuit with a quadrature

encoder pulse. Full synchronization of these inputs is performed on-chip. Direction or leading-quadrature pulse

sequence is detected, and GP timer 2 is incremented or decremented by the rising and falling edges of the two

input signals (four times the frequency of either input pulse).

TMS320F241FN Datasheet(PDF) 33 Page - Texas Instruments

TMS320F241FN Datasheet(HTML) 33 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66

Datasheet Download

Link URL