7643 datasheet(131/424 Pages) RENESAS

131 / 424 page

Rev.2.00

Aug 28, 2006

page 10 of 202

7643 Group

REJ09B0133-0200

APPLICATION

2.1 I/O Port

2.1.5 Notes on I/O port

(1) Notes in standby state

In standby state✽1 for low-power dissipation, do not make input levels of an I/O port “undefined”.

Pull-up (connect the port to VCC) or pull-down (connect the port to VSS) these ports through a

resistor.

When determining a resistance value, note the following points:

• External circuit

• Variation of output levels during the ordinary operation

When using built-in pull-up resistor, note on varied current values:

• When setting as an input port : Fix its input level

• When setting as an output port : Prevent current from flowing out to external

q Reason

The potential which is input to the input buffer in a microcomputer is unstable in the state that

input levels of an I/O port are “undefined”. This may cause power source current.

✽1 standby state: stop mode by executing STP instruction

wait mode by executing WIT instruction

(2) Modifying output data with bit managing instruction

When the port latch of an I/O port is modified with the bit managing instruction✽2, the value of the

unspecified bit may be changed.

q Reason

The bit managing instructions are read-modify-write form instructions for reading and writing

data by a byte unit. Accordingly, when these instructions are executed on a bit of the port latch

of an I/O port, the following is executed to all bits of the port latch.

•As for bit which is set for input port:

The pin state is read in the CPU, and is written to this bit after bit managing.

•As for bit which is set for output port:

The bit value is read in the CPU, and is written to this bit after bit managing.

Note the following:

•Even when a port which is set as an output port is changed for an input port, its port latch holds

the output data.

•As for a bit of which is set for an input port, its value may be changed even when not specified

with a bit managing instruction in case where the pin state differs from its port latch contents.

✽2 Bit managing instructions: SEB and CLB instructions

(3) Pull-up control

When using port P2, which includes a pull-up resistor, as an output port, its port pull-up control

is invalidated, that is, pull-up cannot be enabled.

q Reason

Pull-up/pull-down control is valid only when each direction register is set to the input mode.

7643 Datasheet(PDF) 131 Page - Renesas Technology Corp

7643 Datasheet(HTML) 131 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL