7643 datasheet(206/424 Pages) RENESAS

206 / 424 page

Rev.2.00

Aug 28, 2006

page 85 of 202

7643 Group

REJ09B0133-0200

APPLICATION

2.5 DMAC

(3) DMA execution

The selected channel transfers one byte of data from the address indicated by its source register

(address 4216 or 4316) into the address indicated by its destination register (address 4416 or 4516)

with at 2 cycles of

φ.

The operataion of the source registers and destination registers after transfer completion can be

selected between decreased/increased by 1 and no change with bits 0 to 3 in the DMAC channel

x mode register 1.

When the transfer count register underflows, the source registers and destination registers are

reloaded from their latches when the DMAC register reload disable bit (DRLDD) is “0”. If the

DRLDD bit is set to “1”, a reload is disabled.

A read/write must be performed to the source registers, destination registers and transfer count

registers as follows:

Read from each higher byte first, then the lower byte

Write to each lower byte first, then the higher byte.

Figure 2.5.12 shows the basic operation of registers transferring.

Tables 2.5.1 and 2.5.2 shows the address directions and examples of transfer result.

(1) Read cycle

DMAC

DMAxSL, DMAxSH

DMAxSL, DMAxSH latch

DMAxDL, DMAxDH

DMAxDL, DMAxDH latch

DMAxCL, DMAxCH

DMAxCL, DMAxCH latch

Temporary register

Incrementer/

Decrementer

Transfer

source

Transfer

destination

➀

➁

➂

➃

➀Transfer source address is specified.

➁Contents of DMAxCL, DMAxCH are

updated by Decrementer.

➂Contents of DMAxSL, DMAxSH are

updated by Incrementer/Decrementer.

➃Data is read

from

memory

and

retained in Temporary register.

Memory

(2) Write cycle

DMAxSL, DMAxSH

DMAxSL, DMAxSH latch

DMAxDL, DMAxDH

DMAxDL, DMAxDH latch

DMAxCL, DMAxCH

DMAxCL, DMAxCH latch

Temporary register

Incrementer/

Decrementer

➄

➅

➆

Transfer

source

Transfer

destination

Memory

Transfer

source

Memory

➄Transfer destination address is specified.

➅Contents of DMAxDL, DMAxDH are

updated by Incrementer/Decrementer.

➆Contents of temporary register is written

into memory.

Note: The temporary register is an internal use register, so that it cannot be read out or written into by program.

Fig. 2.5.12 Basic operation of registers transferring

7643 Datasheet(PDF) 206 Page - Renesas Technology Corp

7643 Datasheet(HTML) 206 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL