T1X06000GA-N1-R3 datasheet(37/118 Pages) TOSHIBA

37 / 118 page

T1000 Series UPS 5.6-6kVA Installation and Operation Manual – 91074-005

10.2 Startup (Normal)

Once the initial operating parameters have been set (Section 10.1), the UPS can be started from a

shutdown condition by following these steps:

1. Switch on MCCB1. The ONLINE/FAULT LED will briefly illuminate, then turn off.

ONLINE/FAULT LED - Off

AC INPUT LED - Steady Green

2. Press and momentarily hold (~2 sec.) the RUN/STOP push button until it beeps. The ONLINE/FAULT

LED should glow steady green.

ONLINE/FAULT LED - Steady Green

AC INPUT LED - Steady Green

3. The UPS is now Online.

10.3 Bypass

The UPS can be placed in Bypass by following these steps:

NOTE: The UPS can be placed in Bypass mode only if the Input and Output voltage parameters are set

the same (e.g. 240 Vin/240 Vout, 208 Vin/208 Vout). Bypass is disabled if the Input and Output

voltage parameters are different.

UPS is Initially OFF

1. Switch on MCCB1. The ONLINE/FAULT LED will briefly illuminate, then turn off. The UPS is in

Bypass.

ONLINE/FAULT LED - Off

AC INPUT LED - Steady Green (If the AC INPUT LED is Off, then Bypass has been disabled.

See 10.3 NOTE.)

UPS is Initially ONLINE

1. The Online state will show:

ONLINE/FAULT LED - Steady Green

AC INPUT LED - Steady Green

2. Press and momentarily hold (~2 sec.) the RUN/STOP push button until it beeps. The ONLINE/FAULT

LED will turn off.

ONLINE/FAULT LED - Off

AC INPUT LED - Steady Green (If the AC INPUT LED is Off, then Bypass has been disabled.

See 10.3 NOTE.)

T1X06000GA-N1-R3 Datasheet(PDF) 37 Page - Toshiba Semiconductor